Heating
Furnace repair in Idaho Falls
When the furnace quits, the house cools quickly on a sub-zero night. Here is what to look at before you call, and what the contractor will check.
You talk to an independent HVAC contractor. Idaho Falls HVAC Repair does no heating or cooling work itself.
Signs it needs a repair visit
- No heat at all, and the thermostat screen is on and calling for heat.
- The blower runs but the air from the registers is cool.
- The burners light, run a minute, then shut off and try again.
- A grinding, squealing or booming noise when it starts.
- A light on the control board blinking a pattern you don't recognize.
- A breaker or the furnace switch that keeps tripping.

Three checks that take five minutes
Set the thermostat to heat and a few degrees above room temperature. Replace its batteries if it has them.
Find the light switch on or near the furnace, which is its power switch, and make sure it's on. Check the breaker.
Look outside at the plastic intake and exhaust pipes if the furnace has them. Drifting snow or frost can block them and the furnace will shut itself down until they are clear.

What a contractor usually tests
A modern gas furnace runs through a set sequence: inducer fan, pressure switch, igniter, gas valve, flame sensor, then the blower. The contractor watches where the sequence stops. Common culprits are a cracked hot surface igniter, a flame sensor coated with residue, a pressure switch tube full of water, a failed inducer motor, or a limit switch tripping because the filter is clogged.
Older furnaces with a standing pilot have a thermocouple that can wear out. Either way, the diagnosis decides whether a part swap fixes it or the cabinet has bigger problems.
When to leave instead of troubleshooting
A rotten-egg smell means gas. Get everyone out, then call Intermountain Gas at 800-548-3679 and 911 from outside, as the gas company advises. If a carbon monoxide alarm sounds, go outside and call 911. The carbon monoxide guide has more.
Questions
Is it worth fixing a furnace that is 20 years old?
Sometimes. A single failed part on a sound cabinet is often worth replacing. A cracked heat exchanger, repeated failures or a failed blower and control board together point toward replacement.
Does a furnace repair need a permit?
Swapping a part usually doesn't, but replacing the appliance does. Ask the contractor, and see the hiring guide for who issues permits where.
Can I keep running a furnace that short cycles?
It will keep the house warmer than nothing, but frequent restarts wear the igniter and controls. Have it looked at soon.
Cold house, warm house, or a system on its last legs?
Dial, mention your town and describe what the equipment is doing. An independent HVAC company that takes jobs around Idaho Falls picks up.